9/4/2023 0 Comments Liquid air coolingIf the water moves too quickly, it doesn't have time to absorb heat before moving on. Its flow rate determines how quickly the coolant moves through the tubes and blocks. The pump is one of the most important parts of the PC's cooling system. If you're thinking about using a submersible pump, make sure its exterior doesn't get hot enough to heat all the fluid in the reservoir. Some PC liquid-cooling pumps are submersible, and you can place them directly inside the PC's coolant reservoir. Vilgun/ShutterstockĪ liquid cooling pump for a PC is usually a centrifugal pump, much like you'd find in a car's cooling system. Pumps, like this one, are the most important parts of a liquid-cooled PC system because they control how fast or slow coolant moves through the system's tubes and blocks. Like a car engine, if the chip gets too hot, it will fail. The more transistors a chip contains and the faster they change states, the hotter the microchip gets. As transistors change their states between on and off, electricity moves around in the microchip. A computer's microchips are full of electrical transistors, which are basically electrical switches that are either on or off. Computer components, on the other hand, generate heat as a byproduct of moving electrons around. Without the radiator's surfaces contacting the air and dispelling the heat, the system would just move the heat around instead of getting rid of it.Ī car engine generates heat as a byproduct of burning fuel. In this way, the engine's heat moves out of the cooling system and into the surrounding air. The radiator warms the air, cooling itself off at the same time. At the same time, a fan moves air over the outside of the radiator. The cool water then heads back to the engine. Heat moves from the hot water to the radiator, causing the water to cool off. The water circulates from the engine to the radiator, a system of fans and tubes with a lot of exterior surface area. Hot surfaces in the engine warm the water, cooling off in the process. A car's cooling system circulates water, usually mixed with antifreeze, through the engine. When you lift your hand, your palm will be a little cooler, and the spot where your hand was will be a little warmer. You can experience this principle firsthand by putting your hand flat on a cool spot on your desk for several seconds. As the cooler object gets warmer, the warmer object gets cooler. Both take advantage of a basic principle of thermodynamics - that heat moves from warmer objects to cooler objects. It might seem a little counterintuitive to put liquids near delicate electronic equipment but cooling with water is far more efficient than cooling with air.Ī liquid-cooling system for a PC works a lot like the cooling system of a car.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |